Hold Fast Vacuum Chucking Systems
An economical, complete Vacuum Chucking system:
Hold Fast Video with Dave Hout
- All you need is a Wood Lathe and a standard Air Compressor.
- Works with almost any #2 Morse Taper lathe with hole through spindle.
- 1"x8, 1-1/4"x8, and 33mm spindle chucks and adapters
- Quiet operation.
-
Practical numbers:
Compressors with an 11 gallon tank that compresses air to approximately 130psi and then turn back on at approximately 85psi will cycle on and off every 3 to 3-1/2 minutes during use.
Compressors with smaller tanks will cycle more often, larger tanks - less often.
Hold Fast pictures with brochure
Hold Fast Spindle Adapters and Accessories
Hold Fast customer ideas and comments
